Hi,
yes, this is possible. It's mainly based on the Conductance probe's 'Desired value' resulting in a 'Control upwards' or 'Control downwards'.
These commands can be assigned to a switchchannel, which are mapped to each 'Dosing pump' of your MaxiDoser.
With the large range of possiblities of the Programmable logic, you can include also fail-safe functions and stop dosing during ongoing alarms, for example.
Here's an example that works quite well:
ProgLogic_Switchchannels.jpg
Fill water 1: At-Top-Off level control
Fill water 12: Leak detection
S33: RO/DI water
S34: Salt water with slightly higher salinity
Maybe other users want to show you their configrations as well and you pick the one you like most or experiment yourself a bit.
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks