Hi may I know what kind of cable of 0-10v should I order if want control Aquatic hybrid dx18 from GHL ? Below is dx18 dimmable adaptor (3.5mm)
Hi may I know what kind of cable of 0-10v should I order if want control Aquatic hybrid dx18 from GHL ? Below is dx18 dimmable adaptor (3.5mm)
We modified one of our older Archon controller wires to create a wire for the Profilux Mini we are using at the office.
With the 3.5 male stereo cable the back section of the wire is ground, the middle and tip are the two 0 -10 V outputs. We then placed the wires in a phone jack connector with position 2 white wire (+), position 3 black (-) and position 5 red (+).
Pin placement.png
IMG_2080.jpg
IMG_2081.jpg
Last edited by AquaticLifeProducts; 12.08.2019 at 22:26.
Thanks your info.
DIY cable is able to control, but not able completely shutdown dx18 when scheduler is running at 0%, may I know if there anything else need to set it from GHL P4 ?
You can alternatively connect an EVG-AP-2F-HIC in between, so the lamp will be completely disconnected from the power line.
regards Pit
You can still use that apex cable by cutting the RJ45-end and connecting the two wires to our Breakout box accessory. This accessory then connects directly to the 1-10V port on the ProfiLux.
Bookmarks