Hi,
at first configure the temparature sensor to trigger cooling and heating at the right temparatures with hysteresis (check the programming guide for more info: https://www.aquariumcomputer.com/dow...g-guide-v7-02/)
Then set three programmable logics:
- One with your sensor input ON AND Temperature Chiller
- One with your sensor input OFF AND Temperature Heater
- And one with prog. logic 1 INVERT AND prog. logic 2 INVERT
Then assign the third prog. logic to the switch channel.
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks