Zeige Ergebnis 1 bis 4 von 4

Thema: Assign a Doser 2.0 SA as a slave to a 2.1 SA

  1. #1
    Registriert seit
    01.08.2019
    Beiträge
    3

    Standard Assign a Doser 2.0 SA as a slave to a 2.1 SA

    Hi. I have an old 2.0 SA doser but the WiFi card appears to be faulty and it won’t connect. Is there a way to connect it to my other 2.1 SA doser and act as a slave to it so it appears in myGHL app? I’m assuming the PAB cable but what software steps are involved.
    Thanks in advance.
    Geändert von Stemanic (02.08.2019 um 16:25 Uhr) Grund: Spelling

  2. #2
    Registriert seit
    27.05.2015
    Beiträge
    1.510

    Standard

    Hi,

    Yes, you can run the 2.0 SA as a slave doser.
    Just make sure this doser is running on the newest firmware before proceeding any further.

    In order to convert this doser to "Slave" mode, you will have to connect to it either by USB or it's hotspot signal. Once connected, go to the General settings page and set this doser to Slave mode, Save.
    Disconnect from the doser, connect it to the D2.1 SA using a PAB-cable and follow the pab-device assignment steps shown here:

  3. #3
    Registriert seit
    01.08.2019
    Beiträge
    3

    Standard

    Thanks I will try that

  4. #4
    Registriert seit
    01.08.2019
    Beiträge
    3

    Standard

    Worked perfectly thank you.
    Only issue I had is that while I was updating the 2.1 firmware I had the slave connected. Ended up having to do an emergency reset. Which is fine... however the file locations explained in the manual for the reset are actually not the correct locations in the GHL control centre program files. I think this document needs to be updated.
    Found them in the end though and all is well now.
    Thanks for your help.

Forumregeln

  • Es ist dir nicht erlaubt, neue Themen zu verfassen.
  • Es ist dir nicht erlaubt, auf Beiträge zu antworten.
  • Es ist dir nicht erlaubt, Anhänge hochzuladen.
  • Es ist dir nicht erlaubt, deine Beiträge zu bearbeiten.
  •