Results 1 to 5 of 5

Thread: Profilux 4 + Powerbar 6D-D (Non PAB)

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Join Date
    23.03.2011
    Posts
    20

    Default Profilux 4 + Powerbar 6D-D (Non PAB)

    Hi guys, I have an issue with setting up my powerbars.
    Until now, I had 1 powerbar connected to S1-S4, and 2'nd powerbar to S5-S8, so the sockets numbering was 1-6 for 1'st powerbar and 25-30 for 2'nd powerbar. I want to add 3'rd powerbar, and daisy chain all three powerbars together at S1-S4 profilux 4 port. And I have big problem - I can't change socket numbering. I am doing exactly like this:

    1. Connect only one powerbar at time to S1-S4 Profilux4 port.
    2. Make sure there is a tick at checkbox "Digital powerbar connected on S1-S4 (outputs 1-24)".
    3. Click "Program powerbar or dosing pump unit ..."
    4. Select radiobutton "Numbering of a digital powerbar".
    5. Change using up/down arrows number to 7 and click next.
    6. Hit Program Now button.

    After this a Ready button appears, but nothing has been changed. Powerbar is still as channels S1-S6, not S7-12 (I did activated manual override, and pressing S7 On/Off did nothing, but pressing S1 On/Off changed the state). It does not matter wchich of the two PowerBars I try to program. I have also checked, that trying to program initial state is not working too at both Powerbars.

    So my question is - is there any compatibility problem with P4 and PowerBar 6D-D? My Firmwareversion: 7,21 GCC: 1.1.2.6
    And other question - what is the pinout of the RJ12 6P6C cable? Is it straight cable or cross-over/custom connected? Maybe I have bad cable?
    Last edited by premiero; 02.08.2019 at 16:12.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •