Hello all,

I posted this thread in the English forum, but have not had any answer for a while, so I will try in the German section.

New to the forum and recently found these lights. Based on the research this seems to be some of the best lights out there, so I have decided to upgrade my Juwel Rio 125 MultiLux setup with a Mitras Lightbar 2.
The idea is to have the Lightbar 2 sitting in the middle with the flat brackets so it is level and have the flaps sit on each side freely, as I do not think it is a good idea to put a hood above the light due to heat issues.

My question is as follows, what exactly do I need to ensure I got everything running?

So far what I understand and think, I am going to get this:
Mitras Lightbar 2 (80 cm)
Mitras-LB-PSU80 (Power supply unit)
Flat Holding Brackets
Profilux Mini Wifi
LB Cable RJ45

Is all this enough to make sure that the light works, is dimmable, I can configure any light spectrum, set sunrise/sunset and whatever other options? Or do I need something extra on top?
Any help is greatly appreciated!


-Greg