Hi,
on a ProfiLux controller it is possible to use Virtual Sensors.
You can create them by browsing the menu directly on the ProfiLux and goto system->virtual sensors.
There are 2 options available:
- Average of two probes
- Copy of a probe
In your case it would be good to use 'average' of 2 temp probes and set the alarm threshold accordingly.
Then assign the new virtual sensor to the desired switch channel/prog logic.
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks