Profilux connection help please

**JasonMcK** · 24.01.2010, 02:58

You will not find the address of your Profilux but you can reserve an address to set your Profilux to.

SO you have 3 computers attanched to that router so 3 addresses are already take.

I'm sorry I do not know every router but typically there is a Status page that will tell you who is connected from that page you can tell what IP addresses are used and what are free. As suggested I would guess that 192.168.1.199 is a safe bet to be free why not start with that

**JasonMcK** · 24.01.2010, 03:39

Just responding to your PM.

I can not teach you about your Router as I do not know a lot about it.

I just downloaded the manual.
So when you log in you will see a black bar at the top of the page with the main tabs just below it in blue are the sub tabs. I believe the far right tab is STATUS if you then select Local Network you will see a page with a grey button at the bottom that says DHCP client table Click this and it will display all the computers attached to your router. Post what is there

J

**kvmn** · 24.01.2010, 03:44

with ip address 192.168.1.199 still could not connect

**JasonMcK** · 24.01.2010, 03:49

Please go back throught the instructions step by step.
do you have wireless security on your router?

**kvmn** · 24.01.2010, 03:55

yes i have wireless security in router Enable now

i went through step by step many time but when i get to Ip address screen,,then i am stock,,,don't know what to put in there

**JasonMcK** · 24.01.2010, 04:00

During set up you must turn off wireless security on the router.
You have to connect to the Profilux before you can program the WEP string to the Profilux

BTW is this PII or PIII

**kvmn** · 24.01.2010, 05:10

Originally Posted by JasonMcK

Just responding to your PM.

I can not teach you about your Router as I do not know a lot about it.

I just downloaded the manual.
So when you log in you will see a black bar at the top of the page with the main tabs just below it in blue are the sub tabs. I believe the far right tab is STATUS if you then select Local Network you will see a page with a grey button at the bottom that says DHCP client table Click this and it will display all the computers attached to your router. Post what is there

J

i don't see no pm from u
did u ever send it?

**kvmn** · 24.01.2010, 05:14

Originally Posted by JasonMcK

During set up you must turn off wireless security on the router.
You have to connect to the Profilux before you can program the WEP string to the Profilux

BTW is this PII or PIII

PII EX
ok turned wireless security disable now,,,tried connect but still no luck,,
when i have my Aquacontroller Ip address is 192.168.1.50
i don't know if i can still use that or not