Page 1 of 2 12 LastLast
Results 1 to 10 of 14

Thread: S-L-port BOB

  1. #1
    Join Date
    09.01.2019
    Posts
    7

    Default S-L-port BOB

    Hi,

    I've connected the profilux S port via a S-L port BOB to 4 relays. I tried to assign switch channels to the relays, with the ' Program digital powerbar ' button on the ' switch channels and outlets' page in GCC.
    This does not work, I can't get the relay controlled.
    Is there another way I should be doing this?

    Thanks for the help!

  2. #2
    Join Date
    27.05.2015
    Posts
    2,488

    Default

    Hi there,

    Exactly what device do you have connected to the S/L breakout box?
    Which ProfiLux controller do you have? P4 or P4e?

  3. #3
    Join Date
    09.01.2019
    Posts
    7

    Default

    Hi,

    I have the P4, and the relay is a 12V 4 Channel Relay Module Board Shield with Optocoupler Road High and Low Level Trigger Relay for Arduino. With the relay I want to control solenoid valves and ATO pumps.

  4. #4
    Join Date
    13.08.2010
    Posts
    4,150

    Default

    Remember that the S- interfaces tolerate max. 10mA.

    regards pit

  5. #5
    Join Date
    09.01.2019
    Posts
    7

    Default

    relay.jpg

    this is the relay, should work or not?

  6. #6
    Join Date
    13.08.2010
    Posts
    4,150

    Default

    I don't know how much mA need the board

  7. #7
    Join Date
    12.04.2015
    Posts
    364

    Default

    Je nach ausführung nimmt das relai 0,36 oder 0,45 watt
    http://www.circuitbasics.com/wp-cont...-Datasheet.pdf
    0.45 watt / 12 volt macht ca. 0,04 A und damit einen gegrillten port am Profilux. Da musst du noch eine extra stromquelle und einen transistor zwischen klemmen.

  8. #8
    Join Date
    12.04.2015
    Posts
    364

    Default

    Nachdem ich mir das höre nochmal angesehen habe, sind die transistoren da evtl. Schon drauf. In dem fall brauchst du mindestens eine extra stromquelle und kannst evtl die schaltausgänge vom profilux direkt nutzen. Hast du ein datenblatt vn dem bord?

  9. #9
    Join Date
    09.01.2019
    Posts
    7

    Default

    The trigger current is 5mA, so this should be fine no? I can try with a separate power supply. Is my way to assign the numbering to the switch channels the right way, or is there another way?

    Thanks for the help!

  10. #10
    Join Date
    09.01.2019
    Posts
    7

    Default

    The trigger current is 5mA, so this should be fine no? I can try with a separate power supply. Is my way to assign the numbering to the switch channels the right way, or is there another way?

    Thanks for the help!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •