Results 1 to 4 of 4

Thread: Calcium reactor mode

  1. #1
    Join Date
    21.11.2014
    Location
    Gdynia, Poland
    Posts
    57

    Default Calcium reactor mode

    Przechwytywanie.JPG

    Why can't change over 6.00PH ?

  2. #2
    Join Date
    09.03.2019
    Posts
    2

    Default

    I can't see other options but there might be some dependency parameters that prevent that to go higher.

  3. #3
    Join Date
    09.03.2019
    Posts
    2

    Default Control two Ph Probes in calcium mode?

    I am new to GHL and especially a newbie to KH Director. I have two calcium Rx ( with two ph probes of course) and would like to have Kh Director to control both Ph in both probes. Will this be possible?
    thanks in advance for any helps

  4. #4
    Join Date
    04.11.2015
    Posts
    1,061

    Default

    Quote Originally Posted by hienvu View Post
    I am new to GHL and especially a newbie to KH Director. I have two calcium Rx ( with two ph probes of course) and would like to have Kh Director to control both Ph in both probes. Will this be possible?
    thanks in advance for any helps
    This will be available in the next firmware release soon via the switchchannel functions.
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •