Hi,
Is it possible to program your Probe/Sensors to turn off during Feed or Maintenance Mode?
Or is it possible to create a programmable logic program to make the Probes and Sensors to turn off?
GHL Control Center V1.1.2.1
Many thanks.
Hi,
Is it possible to program your Probe/Sensors to turn off during Feed or Maintenance Mode?
Or is it possible to create a programmable logic program to make the Probes and Sensors to turn off?
GHL Control Center V1.1.2.1
Many thanks.
What do you mean by "turn off"?
Under what circumstances would these probes need to be "off"?
Hi Vinny,
Many thanks for replying on this thread.
When I hit the feed mode and turn my Vortechs and Return Pump down I see a sharp decline in my pH probe reading, which returns to an normal/expected value once the return pump is back to normal flow. Therefore I was looking to disable the pH probe whilst entering feed or maintenance mode.
Bookmarks