Results 1 to 3 of 3

Thread: ORP and timer in one

  1. #1
    Join Date
    02.12.2016
    Posts
    43

    Default ORP and timer in one

    Hi,
    I have Profilux 4 full set...
    I'm using Ozone reactor and have connected the Ozone generator to Bar 5.1 plug

    At the moment I can only operate it either on timer or under Redox probe readings

    I would like to use both at the same time. I would like to set the timer switching on few times a day and IF ORP is above set point it would switch off

    So I went to
    Programmable logic

    Input 1 - I chose timer (selected the created time schedule)
    Input 2 - I chose OR Redox 1 with value settings,

    Then I assigned this programmable logic to my plug but .....
    The problem I have is that it only still operates under Redox probe and switches the ozone generator on until the nominal value is fully reached

    I would like the timer to switch the generator on only for few times a day so the ozone doesn't get pumped in at once while staying off after that for days until it falls back to normal values.

    Basically I need
    Timer - One hr on then few hrs off... few times a day and IF ORP above 380 then OFF

    How do I do this please?

    Many thanks!
    Last edited by Bagirka; 05.02.2019 at 10:05.

  2. #2
    Join Date
    02.12.2016
    Posts
    43

    Default

    It seems to work on Equal not on OR
    Last edited by Bagirka; 05.02.2019 at 12:28.

  3. #3
    Join Date
    25.01.2017
    Posts
    16

    Default

    Hi
    Use "and"

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •