-
PLM-4L problem
Hi !
I bought a used Profilux 2 plus with PLM-4L . L1-L7 /1-10v/ ports working good, but the L8 do nothing.
In the PC program, i see the profilux control it, but I measure it , and 0v coming out...its possible only this one port not working ??
-
Yes, it's possible.
Without knowing how the previous owner cared for the equipment, perhaps this port had been damaged.
-
Thanks !
When i'm buy one new plm-4l card , can i disble the not working port ?
Profilux 2 plus can control 10 L port , have 4 on board /L1/2 + L3/4/+ 4 with the new plm-4l card /L5/6 + L7/8 / and need 2 from the defekt plm-4l card. But how can i do, the L9/10 go for the working port, and not the defekt...?
-
Extansion cards are numbered bye the order they are pluged into the profilux. So you may have luck by changing the order you plug the cards into the profilux.
But i ding know what will happen if you plug in more l ports than possible.but it will only work if the higher numbers at your card are defekt.
-
Thanks for the answear ! I'l will try the new plm card in the first socket, and the bad card in the second, and i hope, the non working port go to the L11/12 and L1-10 will working.....
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks