Results 1 to 5 of 5

Thread: PLM-4L problem

  1. #1
    Join Date
    30.01.2014
    Posts
    20

    Default PLM-4L problem

    Hi !

    I bought a used Profilux 2 plus with PLM-4L . L1-L7 /1-10v/ ports working good, but the L8 do nothing.

    In the PC program, i see the profilux control it, but I measure it , and 0v coming out...its possible only this one port not working ??

  2. #2
    Join Date
    27.05.2015
    Posts
    2,493

    Default

    Yes, it's possible.
    Without knowing how the previous owner cared for the equipment, perhaps this port had been damaged.

  3. #3
    Join Date
    30.01.2014
    Posts
    20

    Default

    Thanks !

    When i'm buy one new plm-4l card , can i disble the not working port ?
    Profilux 2 plus can control 10 L port , have 4 on board /L1/2 + L3/4/+ 4 with the new plm-4l card /L5/6 + L7/8 / and need 2 from the defekt plm-4l card. But how can i do, the L9/10 go for the working port, and not the defekt...?

  4. #4
    Join Date
    12.04.2015
    Posts
    368

    Default

    Extansion cards are numbered bye the order they are pluged into the profilux. So you may have luck by changing the order you plug the cards into the profilux.
    But i ding know what will happen if you plug in more l ports than possible.but it will only work if the higher numbers at your card are defekt.

  5. #5
    Join Date
    30.01.2014
    Posts
    20

    Default

    Thanks for the answear ! I'l will try the new plm card in the first socket, and the bad card in the second, and i hope, the non working port go to the L11/12 and L1-10 will working.....

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •