Hi,

Please could someone advise how I can rescue a Doser 2.0 Slave & ProFiLux Touch following an attempted firmware update that went wrong, from a ProfiLux 3.1N?

Following the issues with the devices I decided to perform a PAB System Reset and following this the below is seen.

Doser 2.0 Slave: No longer shows the central colour GHL led but the green Com LED is solid green and the State LED flashes yellow. When connecting to the Control Centre the device no longer shows when clicking assign devices.

ProFiLux Touch: The Interface has a green flashing light and the Touch Screen shows the opening screen on power up and thats it. When connecting to the Control Centre the device no longer shows when clicking assign devices.

--

For both devices I have connected individually to the ProfiLux 3.1N and the same, it does not see them anymore.

I reverted the ProfiLux 3.1N settings to before the issue and the same.

Uninstalled the Control Centre and reinstalled, same issue.

I have been able to connected another Doser 2.0 Slave so the ProfiLux 3.1N seems OK.

Is there a way to flash these devices or factory reset?

Help please!