-
Doser 2 First Time Contrl
Hi, and sorry for the newbie question.
I have been given a box of GHL doser kit including the below and a couple of sensors and I am in need of advice.
GHL Doser 2 4fach, sw
GHL Doser 2 Slave, 4fach, sw
GHL Pofilux Touchscreen
GHL Expansion Box
GHL Dosing Unit Four (same age and design as the expansion box)
Neither of the two doser 2's have a USB port or ethernet port so logic would say they are both slaves despite only one being marked as a slave. Connecting the PAB connection to either of the doser 2's or the expansion box brings about them showing on the Profilux Touchscreen. Chaining the devices with PAB neither brings back a connection either.
I've searched the forum and google etc with no joy on what the 'GHL Doser 2 4fach, sw' device is.
Guessing the 'GHL Doser 2 4fach, sw' is not a standalone device due to the lack of USB port or those shown in the manual so assuming I need to either purchase a doser 2 stand alone or a profilux 3 or 4 to control the dosers?
So please if someone could point me in the right direction I would be so thankful.
Sorry for the newb, question.
Regards, Starmonkey77
-
Hello,
If the doser has no USB port, level port, or temperature port...it is a SLAVE unit.
In this case, these dosers and additional items you have (EXB1, Touch, Gen1 doser) would need to be assigned to a ProfiLux 3 or 4. If you wish to control all those devices, a ProfiLux 3 or 4 would be needed.
If you purchase a Standalone Doser 2.1, you would be able to control both Doser 2.0 pumps. The Gen1 doser would not be able to be controlled by a Standalone Doser 2.1 as the Gen1 doser is not compatible.
-
Thank you Vinny, very much appreciated!!
Best get purchasing a ProfiLux 3 or 4 then.
-
Morning Vinny,
If I were to purchase a Doser 2.1 and a Maxi doser and connect these to the Extension box, would I be able to run the additional sensors from the Extension box and the Pofilux Touchscreen?
-
Actually could I purchase just a Maxi Doser SA.
Whereby this controls the Doser 2.0 slave, but could the Maxi Doser SA then control the Expansion box and therefore the additional sensors off that? (Edit I see that its now not possible to link the Expansion box to the Maxi Doser).
Would it be possible for the Maxi Doser SA to manage a Doser 2.0 and a KH Director?
Last edited by starmonkey77; 15.11.2018 at 16:00.
-
Hi Vinny,
I've purchased a ProfiLux 3.1N so looking forward to having a play at the weekend with all the kit.
-
Hi,
Congrats on the purchase.
To answer your questions, once a standalone Doser 2/2.1 is switched to SLAVE mode, the on-board ports are disabled.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks