Results 1 to 2 of 2

Thread: Required components for Mitras Lightbar 2 on reef tank

  1. #1
    Join Date
    24.10.2018
    Posts
    1

    Default Required components for Mitras Lightbar 2 on reef tank

    Hi,

    what are the components I need for equiping my reef tank with Mitras lightbar 2? The tank is 160x70x70 cm.
    I have a lot of SPS Coral, so I think i need 3 150cm Lightbar units. What would you recommend?

    I'm thinking about the following components. Is this correct?
    1x Profilux Light controller
    1x Mitras-LB-Cable RJ45
    2x Lightbar 2 arctanic 150cm
    1x Lightbar 2 deep arctanic 150cm
    3x PSU 100 W
    1x LB-splitter

    What is the recommended installation height from the water surface?

    Is there a WiFi extension possible for the light controller?


    With regards,
    Vincent

  2. #2
    Join Date
    27.05.2015
    Posts
    2,486

    Default

    Hello Vincent,

    3x Mitras Lightbar in the 150cm size is a good choice.

    With our Lightbars, you only need 1 power supply. This PSU is connected to the LB-splitter and must be large enough to power all 3 LBs. By doing the 150cm versions, you would have a total wattage draw of 295.5 watts which means you would need 1x PSU300.
    The rest of your list looks good!

    Since these LB are sealed against water, you can have these kept closer to the water. These can be positioned right onto the rim of the tank which make it only about 10cm away from the water.

    The ProfiLux Light controller does not have built-in WiFi. The connection option for this controller is through USB.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •