I had an combination with P4 and the mitras light bar 2 working well without problems. Of different reasons I had to switch over to a combination of a P 3.1T and an expansion box 2. Firmware 3.1T - 6.36 and for Expbox 2 2.04. I attach my mitras to the exp box 2. It works well but now and then - the light bars flashing up or going down for second or two. I have no flash or other simulation activated. I have also noted that my proppeler breeze now and then just accelerate up my fans for a second or two - often happens when the fans should not run because of to low temperature. This indicate some rush in the 1-10 V system. The breeze is connected to L6 in the P 3.1 T and the 9 channels of my mitra led bar 2 configuration is attached to the exp box 2. Any thoughts?

Sincerely Lasse