Please open the ExpansionBox configuration via GHL Control Center System page and disable the temp sensor. Then reconnect to the ProfiLux and enable the sensor again.
Does this solve your problem?
Please open the ExpansionBox configuration via GHL Control Center System page and disable the temp sensor. Then reconnect to the ProfiLux and enable the sensor again.
Does this solve your problem?
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
I´ll try that but I have this problem in two different installations - at home and in a fish farm. At the fish farm I have two different computers (3.1T) with digital temp probe at an exp box 2 - two different production lines. The same with both - plenty of alarms from the temp probe in exp box 2. At home - as you can see in post 1 - the same problem. I have set up a test system with 1 P4, one dos pump 2.1 and one expansion box 2. One digital probe in the P4 and one in the exp box 2. In one hour - have had one short alarm. Configure with sample time 1 minute and e-mail alarm to my e-post. The test will be for a while - see whats coming up. It looks like Faltaren have exactly the same problem. Although - we are swedes both of us - we are around 250 km apart from each other . I´ll test the way you say - coming back with result later on - but I think it is a more general fault - somehow connected with the communications in Exp box 2
Sincerely Lasse
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
I have now let my test run for nearly a day. Two digital temp probes - one connected to a expansion box 2 and one to PL4. Both P4 and ExpBox2 with the latest firmware. For experimental design see last picture post 4. Sample time 1 minute Temp 1 = digital temp probe P4 and Temp 2 = digital temp probe Exp Box2. The fault signal is only around 1 sec and it is only sometimes you can catch this signal with help of a sample time at 1 minute. The fault time is normally short and it is not always an alarm will be sent out. I got one alarm yesterday at 15:33.
The graph show two occasions with a faulty temp - both from probe 2 - the ExpBox2.
I think you have an issue with expbox2 and at least the digital temp.
Sincerely Lasse
At 08:00 I did as you suggested in post 8. The test continue.
I think there is some issues with the PAB in expBox2 because in two installations at the fish farm with ExpBox 2 - we have plenty of PAB alarms and digital temp alarms. In two similar installations at the same place - but with expbox 1 (no digital temp probe) - nema problema with PAB communication alarms
In another installation at the maritim museum of Gothenburg with an expansion card for digital temp installed in an expbox1 - nema problema with either temp alarms or PAB communication alarms
Sincerely Lasse
After a reset last day at 8:00 - things have not been better
and from 01:27 this night
Sincerely Lasse
Bookmarks