Results 1 to 4 of 4

Thread: Light composer

  1. #1
    Join Date
    02.01.2018
    Posts
    7

    Default Light composer

    Hello,
    I have an Profilux 4 (firmware 7.15) and try to program a light schedule by the use of the Control Center 1.1.17 but I have a problem.
    First I have assigned my Mitras daylight lightbars and after that I made in Light Composer a schedule
    After that I try to store it, and in Control Center I get the message that is stored but it isn’t
    Om the left side in Control senter are still the old ilummination channels

    I hope you can help me with this problem.
    By the way, the two Light bars are connected, they respond when I make live changes in Light Composer

    I look forward to your answer
    Kind Regards
    Simon

  2. #2
    Join Date
    30.03.2011
    Location
    helsingborg
    Posts
    177

    Default

    I have the same issue. They are looking in to it. Use 1.1.1.2 it works

    Skickat från min G8141 via Tapatalk

  3. #3
    Join Date
    02.01.2018
    Posts
    7

    Default

    Thnx for your reaction, I will try it

  4. #4
    Join Date
    04.11.2015
    Posts
    1,062

    Default

    We will soon release a new GHL Control Center version that will fix the transmission issues of all illumination channels from a Light Composer project.
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •