-
Tunze 6150 Stream 3 Cable requirements?
Hi
So i have 2 Tunze 6150 Stream 3 that i like to connect to my profilux 3.1ex. Which cables do i need. I see there is Tunze 1 & 2, so a bit confusing there. I would like to have 1 pump pulse then the other. Opposite each other. AntiSync so to speak. Is there a step by step guide for this?
-
You need a Y cable, a Tunze 1 cable to control a pump via L1,3,5,etc., and a Tunze 2 to control a pump via L2,4,6 etc.. When you plug the Y cable into L1/2, proceed as follows.
1-10V settings.
L1 stream pump 1 and u.min =~2.8V
L2 stream pump 2 and u.min =~2.8V
Then go to Extras_Stream group 1
Mark pumps 1 and 2 in the right window and press the left arrow
Then under "Mode" you choose permanently opposite.
The rest of the settings you can customize if you use a different interface, you have to choose the right settings
regards Pit
Last edited by PIWAWT; 17.07.2018 at 16:25.
-
Wow, that is awesome. Perfectly understood. Many Thanks
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks