Results 1 to 2 of 2

Thread: Meanwell 60-48P driver and LED control 4

  1. #1
    Join Date
    29.01.2018
    Posts
    3

    Default Meanwell 60-48P driver and LED control 4

    Hi all,
    I have a DIY LED setup that I built a while back. It is using the Meanwell 60-48P drivers (I have 6 drivers for 3 channels). Does anyone know if these drivers will work with the LED control 4? I talked with Mike at Rapid LED, and he said that these drivers need 10V PWM signal going out. I have looked on the forums and haven't been able to find out anything, so you help would be appreciated. Also, can I hook 2 drivers up to one channel?

    Thanks,
    Ryan

  2. #2
    Join Date
    04.11.2015
    Posts
    1,062

    Default

    Hi Ryan,

    there is a thread already, which might help you: https://forum.aquariumcomputer.com/s...n-LED-Control4
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •