-
Charts not up to date.
I’ve just noticed that my charts are showing last updated at 1845 for redox and 1800 for temp, it’s currently 2215. The chart also doesn’t read the current value. Is this because the memory data is full?
I’ve set the measurement data to save every 15 minutes, is that sufficient?
-
Are you viewing these charts on myGHL, app, GHL Control Center?
Memory data is relevant when viewing charts on GCC.
Measurement data every 15 minutes not necessary and will use the storage very quickly. Every 60, 90, or 120 minutes would be sufficient.
-
2367D9DC-131B-429B-A035-EF1162CE5283.jpg
It’s the same for both the app and myGHL.
I’ve changed the time to 90 minutes, does the time only effect the data viewed in GCC or does it also effect myGHL/app?
-
It looks like the graph is up to date again.
Changes in my GCC also affect myGHL / Connect and vise versa.
-
In the screen shot above and at the moment is about 3 hours behind.
-
The 3 hour delay is likely from the time zone setting not being setup yet.
Go to the GENERAL settings page and set the time zone to your location.
-
At the moment it’s 2hr 11min behind. It seems to be catching up slowly, when I first posted about this it was over 4 hours behind. The time zone is set to UTC +0, is this correct for London?
-
-
Oops, I’ll see if that makes any difference. The charts were last updated at 2053 last night, that’s now 11 hours ago!
-
Changing it to UTC +1 seems to make it worse, the charts are now 16 hours behind!
I’m just recovering from losing most of my fish and corals due to overheating so I’m trying to monitor my water in real-time.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks