Page 1 of 3 123 LastLast
Results 1 to 10 of 30

Thread: Charts not up to date.

  1. #1
    Join Date
    30.06.2018
    Posts
    50

    Default Charts not up to date.

    I’ve just noticed that my charts are showing last updated at 1845 for redox and 1800 for temp, it’s currently 2215. The chart also doesn’t read the current value. Is this because the memory data is full?
    I’ve set the measurement data to save every 15 minutes, is that sufficient?

  2. #2
    Join Date
    27.05.2015
    Posts
    2,488

    Default

    Are you viewing these charts on myGHL, app, GHL Control Center?

    Memory data is relevant when viewing charts on GCC.
    Measurement data every 15 minutes not necessary and will use the storage very quickly. Every 60, 90, or 120 minutes would be sufficient.

  3. #3
    Join Date
    30.06.2018
    Posts
    50

    Default

    2367D9DC-131B-429B-A035-EF1162CE5283.jpg

    It’s the same for both the app and myGHL.

    I’ve changed the time to 90 minutes, does the time only effect the data viewed in GCC or does it also effect myGHL/app?

  4. #4
    Join Date
    27.05.2015
    Posts
    2,488

    Default

    It looks like the graph is up to date again.

    Changes in my GCC also affect myGHL / Connect and vise versa.

  5. #5
    Join Date
    30.06.2018
    Posts
    50

    Default

    In the screen shot above and at the moment is about 3 hours behind.

  6. #6
    Join Date
    27.05.2015
    Posts
    2,488

    Default

    The 3 hour delay is likely from the time zone setting not being setup yet.
    Go to the GENERAL settings page and set the time zone to your location.

  7. #7
    Join Date
    30.06.2018
    Posts
    50

    Default

    At the moment it’s 2hr 11min behind. It seems to be catching up slowly, when I first posted about this it was over 4 hours behind. The time zone is set to UTC +0, is this correct for London?

  8. #8
    Join Date
    27.05.2015
    Posts
    2,488

    Default

    London would be +1 UTC.

  9. #9
    Join Date
    30.06.2018
    Posts
    50

    Default

    Oops, I’ll see if that makes any difference. The charts were last updated at 2053 last night, that’s now 11 hours ago!

  10. #10
    Join Date
    30.06.2018
    Posts
    50

    Default

    Changing it to UTC +1 seems to make it worse, the charts are now 16 hours behind!
    I’m just recovering from losing most of my fish and corals due to overheating so I’m trying to monitor my water in real-time.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •