Results 1 to 3 of 3

Thread: Tunze 6150 Stream 3 Cable requirements?

  1. #1
    Join Date
    29.06.2015
    Posts
    8

    Default Tunze 6150 Stream 3 Cable requirements?

    Hi

    So i have 2 Tunze 6150 Stream 3 that i like to connect to my profilux 3.1ex. Which cables do i need. I see there is Tunze 1 & 2, so a bit confusing there. I would like to have 1 pump pulse then the other. Opposite each other. AntiSync so to speak. Is there a step by step guide for this?

  2. #2
    Join Date
    13.08.2010
    Posts
    4,150

    Default

    You need a Y cable, a Tunze 1 cable to control a pump via L1,3,5,etc., and a Tunze 2 to control a pump via L2,4,6 etc.. When you plug the Y cable into L1/2, proceed as follows.
    1-10V settings.
    L1 stream pump 1 and u.min =~2.8V
    L2 stream pump 2 and u.min =~2.8V
    Then go to Extras_Stream group 1
    Mark pumps 1 and 2 in the right window and press the left arrow
    Then under "Mode" you choose permanently opposite.
    The rest of the settings you can customize if you use a different interface, you have to choose the right settings

    regards Pit
    Last edited by PIWAWT; 17.07.2018 at 16:25.

  3. #3
    Join Date
    29.06.2015
    Posts
    8

    Default

    Wow, that is awesome. Perfectly understood. Many Thanks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •