Results 1 to 4 of 4

Thread: Line monitor

  1. #1
    Join Date
    06.07.2018
    Posts
    10

    Default Line monitor

    Updated P4 to latest firmware and try to get Line monitor port to work.

    This is what I have done:

    Connected dc 12v plug to Line monitor port, checked that transformer is working and power is on.

    Turn on power cut monitoring on from GCC system page (use linemon input)

    When I save changes it goes instantly to "power cut" state.

    Try this with two tranformers but result was same. What I should try next?

  2. #2
    Join Date
    04.11.2015
    Posts
    1,062

    Default

    Hello,

    our adapter has 5V (not 12V) and it is modified to make sure that the power cut is recognized quickly and not with a longer delay, which may happen due to the capacitors in a standard (not modified) PSU.
    And as usual: damages caused by a 3rd party products may not be covered by warranty.
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

  3. #3
    Join Date
    06.07.2018
    Posts
    10

    Default

    In manual it says 12v

    3.2.8 Power Failure Monitor/ Line Monitor Port A mains voltage monitor (12V plug-in power supply with jack plug) can be connected to this connection.

    Where I can find that 5v ghl adapter?

  4. #4
    Join Date
    04.11.2015
    Posts
    1,062

    Default

    The ProfiLux 4 adapter for power cut monitoring is available in our store:

    https://store.aquariumcomputer.com/e...onitoring.html
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •