Results 1 to 2 of 2

Thread: doser 2 slave 3 pump the number 2 pump will not stop running

  1. #1
    Join Date
    08.09.2015
    Posts
    48

    Default doser 2 slave 3 pump the number 2 pump will not stop running

    Having an issues with slave dosers I have a number of them I thought it was just one slave doser 2 where the 2nd pump would stay running all the time.
    But I just hooked up a Gen 1 doser and as soon as I connect power to the doser the 2nd pump starts running too. I have a Doser 2.1 also but it doesn't do this problem.
    When I remove the pab cable from the doser 2 the 2nd pump stops running.
    When I remove the s cable from the gen 1 doser the 2nd pump stops running.

    Nothing is set up on either pump in the Profilux 3.1ex

    Some how the profilux is sending out the signal to do this. How do I reset the Profilux to stop this from happening?

  2. #2
    Join Date
    09.11.2017
    Posts
    1,476

    Default

    Porbably "Pump reacts to" is set to "Switch channel" in the pump settings.
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •