Hi,
An honest question. Do I need to re-calibrate after updating the firmware?
I am asking because it is going to be a pain it does.
Currently running P4 with 4 probes, 3x Doser 2.1.
Anyways, Any help/response is much appreciate
Hi,
An honest question. Do I need to re-calibrate after updating the firmware?
I am asking because it is going to be a pain it does.
Currently running P4 with 4 probes, 3x Doser 2.1.
Anyways, Any help/response is much appreciate
Hi,
Do backup of settings AND sensors settings (which contain calibration data) BEFORE firmware update.
Then if firmware update do factory reset (which is often), restore 2 backups files (settings and sensors data) to Profilux.
Gaël
As mentioned, you should always save your controller settings and sensor settings before doing an update. You can always reload both settings in case you need to.
It depends on the firmware jump, if you do a backup (and you should always backup), you might get the error can't restore because of a difference in firmware. Then yes it's the whole process again.
Just hope calibration works.
Bookmarks