Hi all,
I have two Redox probes, one on P4 on the Redox / PH socket ( Redox first means that is the probe connection for redox)
Other one on the Expansion box 1.
Probea are working tested both on a Aquamedic Redox controller.
When I calibrate - null plug then 220v solution I always get an incorrect reading on both devices.
The ACD on null plug goes between 468/9 when I attach the Redox probe ACD is almost the same 468/450.
The probe just reads all over the place keeps creating upwards till I reach 1000mv then stops.
This is happening on both EB1 firmware 1.08 and P4 firmware 7.14.
Any help?
Sent from my SM-G965F using Tapatalk
Bookmarks