Hi all,

I got the Doser 2 not the 2.1 or the one released just after the new doser 2.1.

I am trying to do a firmware update on it but keeps complaining that firmware cannot be updated no matter what!

I followed the instructions to the T but still same error. I am. Connected via USB directly to the doser.

Firmware shown attached. Three questions

1. What's is the difference in any case between the 2.0 & 2.1

2. Is there a way to force flash like the P3/4 have the flash utility. I am referring to the flash utility.

3. If I turn this unit from standalone to linked to my P4, the P4 regonizes it in the PAB assign how ever if I assign it, no error but also no doser. Go back and it pops up again but doesn't have the selection I have to check the box. It never assigns. I have reset PAB and tried again.


Not to sure if its the same bug as Expansion Box 1 when you have to only assign the expansion box first configure it then only you can add the rest of the PABs.


The flash, you have like 1 or 2 seconds to reset into bootloader then flash is a pain.

Looking forward to the info



Sent from my SM-G965F using Tapatalk