Results 1 to 2 of 2

Thread: Updating PAB

  1. #1
    Join Date
    08.06.2018
    Posts
    23

    Default Updating PAB

    I’m just about to set up all my equipment which is a lot.
    When I read the 5.1 powerbar manual it states that only one powerbar is allowed to be connected when updating firmware. Also in the GCC it states that only the device being updated is allowed to be plugged in so I’m guessing it means unplug lever sensors, leakage sensors etc as well?

    It’s ok now because everything is just laying temporarily on a shelf but for future reference:
    Do I really need to unplug and plug in each device individually and update?
    I have 3 powerbars, dozers etc which will be a major pain in the a** to disconnect, move, plug, unplug and set up again.
    Also do I need to unplug all sensors, light controller etc?

    Kind regards
    Kim

  2. #2
    Join Date
    04.11.2015
    Posts
    1,062

    Default

    Hello,

    yes, unplugging all but one PAB device at the same time on the PAB-bus is absolutely necessary.
    Sensors, light controllers etc. can be hooked up, since they are no PAB devices.
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •