I plug the sensor in to the green socket. Assigned flow sensor 1 to connection 1. Calibrated it to 12.4 for my 9000 l/m unit and no flow indicated.
Can anyone tell me what I’m doing wrong
Sent from my iPhone using Tapatalk
I plug the sensor in to the green socket. Assigned flow sensor 1 to connection 1. Calibrated it to 12.4 for my 9000 l/m unit and no flow indicated.
Can anyone tell me what I’m doing wrong
Sent from my iPhone using Tapatalk
From our P4 Programming manual
7 Flow
ProfiLux 4 allows you to connect Flow sensors to our controller. These can be connected to the permanently installed level inputs 1 or 2 and to ProfiLux Expansion cards with level inputs.
By having the flow sensor connected to the green port, you have it connected to LEVEL 3/4 which is incorrectly connected.
Connect your flow sensor to the purple port, LEVEL 1/2.
Hi!!
To take advantage of the thread ... would it work with the Splitter Cable for Level Sensors (PL-LY)?
Thanks
PL-LY splitter cables can be connected to any LEVEL port.
2 flow sensors can be connected to level 1/2 and to a 4Level expansion card.
Ah! Ok, but, last question, Can I use the splitter, connecting the Flow Sensor and a Level Sensor?
Or in other words, can I connect two different sensors (flow and level) to each end of the splitter?
Thank you very much
Bookmarks