Originally Posted by
Vinny
Hi Enea,
You can do this using the MAINTENANCE mode settings.
The info below assumes you already have your ATO function setup.
CONNECT ATO HEATER AND ATO CIRCULATION PUMP
1. Connect the heater to an available powerbar outlet.
2. Connect the ATO circulation pump to an available powerbar outlet.
3. Go to the SWITCH CHANNELS AND OUTLETS settings page, select these sockets and set the function to ALWAYS OFF.
4. Click SAVE CHANGES.
CONFIGURE MAINTENANCE MODE SETTINGS
1. Go to the MAINTENANCE settings page, located in the Extras category. Select an unused maintenance mode.
2. Select the socket that has the ATO pump connected to it and set the state to OFF. Check the corresponding box.
3. Select the sockets that have the heater and circulation pump. Set the state to ON. Check the corresponding boxes.
4. Set how long you want this maintenance mode to be active for.
5. Click SAVE CHANGES.
With the above done, you will be able to run your ATO function normally. Once the maintenance mode is activated, the ATO function/pump will be disabled and your ATO heater/circulation pump will turn ON for the duration of the maintenance mode. When the time expires, the heater and circulation pump will turn OFF, and your ATO functions will continue as normal.
TIP: Make sure you are allowing enough time in the ATO function Max on-time for the ATO pump to dispense the necessary amount of mixed saltwater back into your tank.
Bookmarks