Hi,


I would like to use the AIO top-up tank to prepare the weekly change.

1) Normally the profolux is set up like a normal AIO which controls the sump level with an optical sensor and with a top-up pump.

2) If I press maintenance, the profilux deactivates the top-up pump and the sump sesnore. Activate the movement pump and heater instead.

3)If I disable the maintenance I would like the profilux to disable the movement pump and the heater, activate the top up pump until the float signals that the salt water has finished.
When the float detects that the new osmosis water has been turned off it will re-turn the profilux into normal AIO state (phase 1)
Do you think it's possible ?

Can you help me ?

regards Enea

GHL-Semiwater change.jpg