to
As Matthias wrote:
http://forum.aquariumcomputer.com/sh...1638#post81638 "some deep changes, some parts of the communication stack had been heavily re-worked".
On GCC 1.1.1.2 with same timeout settings: "3000ms" i can backup settings most of time without problem, but with newest GCC most of time it fail.
and
I found something which could help perhaps: I had error code 28 sometimes with GCC 1.1.1.3 and 1.1.1.4. When it happens, there are two solution:
1- reboot my computer,
2- use GCC 1.1.1.2 to connect. So I keep 1.1.1.2 on my computer and use it for that.
the customers here are talking about ProfiLux, not Doser
I changed only one aspect in regards to communication from 1112 to 1113: the Doser gets a regularly keep alive in order to prevent the TCP socket to close down
-> I highly doubt that there is any difference between 1112 and higher versions for P4 communication
so I see no sense in using the outdated 1112
about the timeout
honestly I think it does not matter if you have 1000ms, 3000ms or even 5000ms
if you need that high timeouts than there is something heavily wrong with your Wifi/LAN network
the normal response time is max. 30ms!
in my network it is between 10ms to 20ms
in GCC is a "communication monitor" - activate it and see the reponse times - if there are may red or even black bars then there is a problem in the communication
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks