After updating my P4 to 7.12 and my WiFi to 6619 I randomly get Error 28 or Error 50 when I use TCP/IP connection. I have the same problem both with GCC 1.1.1.3 and GCC 1.1.1.4
Works well with USB cable
Sincerely Lasse
After updating my P4 to 7.12 and my WiFi to 6619 I randomly get Error 28 or Error 50 when I use TCP/IP connection. I have the same problem both with GCC 1.1.1.3 and GCC 1.1.1.4
Works well with USB cable
Sincerely Lasse
Any?
Sincerely Lasse
Hello Lasse
establish a connection via USB, and check the WLAN settings under "System". A screenshot of the settings would be helpful
regards Pit
The setting is the same as before the upgrade. it works without any problems with TCP/IP before update. It works even now but after 5 - 10 minutes - error 28 or error 50 shows up. Screenshot below - I have blank my password
Screen Shot 05-06-18 at 10.37 PM.PNG
Sincerely Lasse
Following along.
I have been having the same issue with the same errors as Lasse. Although it doesn't seem to matter what version of GCC, or firmware. I'm on P4: 7.12 and my WiFi to 6619 and GCC 1.1.1.4. It has happened with all versions of firmware, WiFi and GCC. It just happens much more often now.
Bob
I keep a copy of GCC 1.1.1.2, only for backup/restore settings because always fail during transfert with newest GCC on P4.
Bookmarks