Zeige Ergebnis 1 bis 3 von 3

Thema: the difference measured result of KH Director

  1. #1
    Registriert seit

    Standard the difference measured result of KH Director

    In the strict compliance with the guidelines of the KHD manual, I made the first test and the test result was: 7.5°dKH. It's exactly the same as the result I used to test with Salifert! KHD is great! However, the result of my regular test the next morning was 8.3°dKH. After thinking, I found that the only difference is that the timing test no longer takes the following steps: 1. Vent internal reagent tube ...; 2. Flush measurement cell .... So, after I completed the above steps, the measured result was: 7.6°dKH; then, I tested it again and the result was still: 8.3°dKH. I don't know why this is, but the conclusion is: I want to get the same result as Salifert. I must perform the initial cleaning process before each manual test: 1. Vent internal reagent tube ...; 2. Flush measurement cell .... So I can get the result I want. I would like to ask GHL's servic to consider: Is there any possibility of automatic timing test improvement?

  2. #2
    Registriert seit


    You have the option to modify the KH test result if you strongly feel the salifert readings are more credible.

    You can also recalibrate your KHD probe and see if the KHD results registers a reading closer to the Salifert kit.

  3. #3
    Registriert seit


    you don't need to do the initial steps every time, this makes no sense

    you do this once and the the KHD is good to work

    1 or 2 measurements after initial setup may differ from the real value, needs time to adjust

    -> so your first measurment was a bit too low, the 8.3 masurements seem to be more correct

    -> if you want to see the same value as test kit shows you can manipulate the shown value

    but don't do the initial steps again and again ...
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.


  • Es ist dir nicht erlaubt, neue Themen zu verfassen.
  • Es ist dir nicht erlaubt, auf Beiträge zu antworten.
  • Es ist dir nicht erlaubt, Anhänge hochzuladen.
  • Es ist dir nicht erlaubt, deine Beiträge zu bearbeiten.