The first time I logged in KH Director was listed under dosing pumps. Then it was gone. Then it was under processes and now it has been gone a couple days. Any way to get it back?
Since we wanted to have the same menu structure as in GCC we decided to move the KHD section from dosing pumps to sensors.
Isn't it there a the moment? Then our cloud team wasn't able to finish the repogramming yet, I am sure this will be fixed Monday latest, I need to ask you for some patience.
My KH Director reads almost 2 dkh higher than both of my salifert kits which expire in 2020 and my Hanna checker with 2 different reagent bottles. All Salifert and Hanna reagents read within .1 of each other.
Has been discussed already a few times in this forum so far, other measurement methods show different values.
If you trust those values more then you have 2 options:
1. try to increase accuracy of KHD - recalibrate pH, make sure the pump calibration values are OK (usually 36, 4.5, 36 ml/min)
2. if you think you have the max. accuracy and still trust other values more: manipulate the shown KHD value (+/- % right top corner of KHD settings)
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks