Results 1 to 6 of 6

Thread: Touch Sensor graph range bug

  1. #1
    Join Date
    10.10.2013
    Posts
    994

    Default Touch Sensor graph range bug

    Hi,

    I can't change settings "minimum" and "maximum" in "Sensor graph range".
    I can change and save but after reload, i still see old settings.

    Capture d’écran 2018-03-04 à 19.50.38.jpg

    P4: 7.11
    Touch: 1.06

    Thank

    Gael

  2. #2
    Join Date
    10.10.2013
    Posts
    994

    Default

    Found a trick:
    edit one setting, save
    edit second setting, save
    ->first setting edited is saved.

    But it's really painful ..

  3. #3
    Join Date
    18.02.2009
    Location
    Kaiserslautern
    Posts
    7,710

    Default

    thanks for the hint

    we will have a look into this in GCC 1113
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

  4. #4
    Join Date
    18.02.2009
    Location
    Kaiserslautern
    Posts
    7,710

    Default

    I examined this

    the problem was that GCC marks the line as changed only when you go to the next line, that means as long as you stay in the table at the same place the setting will not be recognized as changed

    moving from the edited line to another would cure it

    -> in GCC1113 I changed this behaviour, the line is marked "dirty" as soon as you start editing
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

  5. #5
    Join Date
    10.10.2013
    Posts
    994

    Default

    Thank Matthias :-)

  6. #6
    Join Date
    10.10.2013
    Posts
    994

    Default

    All is good now with GCC 1.1.1.3.

    Thank

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •