-
Optical sensor will only work once
Unit: Profilux3 eX
Firmware: 5.00g
Software: 5.0.0.4
Hi,
I have just updated the firmware on my unit to 5.00g from the earlier firmware and now my optical sensor on level 1 does not work. It was working fine on the previous firmware.
If I unplug the sensor from Level 1 and then plug it back in again it works once but then does not sense the water levels again.
If the water level is low and I wipe the sensor with my finger it then senses the water and starts the pump. I have cleaned the sensor thoroughly and it seems to be fine.
I don't have a splitter cable or anything else plugged in, just the optical sensor plugged straight into Level 1.
Any ideas why this would be occuring?
Thanks,
Brenton
-
this has nothing to do with the firmware update, it looks like a coincidence - the sensor stopped working at the same time
please contact your retailer for a replacement in the case there is still warranty
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks