Hi,
Thank but like wrote MatthiasF, problem is Profilux side.
Gael
Hi,
Thank but like wrote MatthiasF, problem is Profilux side.
Gael
you don't need to try network debugging with telnet or other protocols or tools, this doesn't help at all
the connection to GCC should just work, we need no network capture etc.
check the ususal and obvious things:
- WiFi (SSID, key, mode, etc.)
- IP gateway subnet etc.
make also sure port 10001 is not blocked
if this all is ok it must work
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Hello,
After rebooting the profilux, the problem was solved.
As MatthiasF said, the server listening on port 10001 was not available and closed the connection:
Trying 192.168.240.94 ...
Connected to esp_b17150.lan.
Escape character is '^]'.
-> Connection closed by foreign host. <-
Nothing to do with my connection or a firewall, especially that I could connect to the P3, proof is given by the fact the reboot of the P4 has solved the problem.
Without insinuating that it was planted, maybe I had badly closed GCC the day before and the port tcp was not released properly (the server listening on port 10001 can only serve one user at a time )
Maybe this will never happen again :-)
Gael
Last edited by Gael; 16.02.2018 at 09:46.
Bookmarks