Results 1 to 5 of 5

Thread: Recommended KH Director setup

  1. #1
    Join Date
    18.12.2017
    Posts
    44

    Default Recommended KH Director setup

    My KHD/2.1 SA Doser comes next week. I am currently using a slave 2.1 connected to my Profilux 4 dosing the triton method. My question is: What is the best setup configuration? The manual covers triton method but want to make my setup can support it. Options:
    1. Hook up slave 2.1 to KHD/2.1 SA Doser and not integrate with profilux 4
    2. Hook up slave 2.1 and KHD/2.1 SA Doser to profilux 4 via PAB
    3. Keep current setup and KHD/2.1 SA Doser as a separate setup
    Appreciate any recommendations. Thanks!

  2. #2
    Join Date
    27.05.2015
    Posts
    2,488

    Default

    Hi there,

    I think it would be more convenient to have a single connection point rather than two separate ones. For that reason, I would set the D2.1SA to Slave mode, then connect it and the KHD to the P4.

    If at anytime your decide to run the KHD and Doser separately, you can easily change the doser back to standalone mode.

  3. #3
    Join Date
    25.11.2017
    Location
    Louisville
    Posts
    39

    Default

    Can we still utilize the temp port and level ports on the stand alone dosers while in slave mode?

  4. #4
    Join Date
    04.11.2015
    Posts
    1,062

    Default

    Hello,

    if Doser is set to Slave mode, it behaves exactly like a Doser Slave and the temperature probe and
    level sensors cannot be used through PAB.
    In this case, you would use the ProfiLux's own probe and level sensors connections.
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

  5. #5
    Join Date
    10.10.2013
    Posts
    994

    Default

    Hi,

    Maybe a day it will be possible with a firmware update to use level and temp port of Doser2 Standalone in slave mode (like an expansion box):
    doser slave.jpg doser slave sensor.png

    Gael

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •