Zeige Ergebnis 1 bis 2 von 2

Thema: Heat did not turn off

  1. #1
    Registriert seit
    31.08.2016
    Beiträge
    12

    Standard Heat did not turn off

    Is there a way to confirm which socket on my energy bar was programmed for my heater? When I set up my Profilux Controller (3.1) I programmed one of the sockets to run my heater and then labeled the socket "Heater". Unfortunately, while plugging and unplugging various components on my energy bar, the individual labels fell off. When I awoke this morning, there was an alarm regarding my tanks temp (83.1). My temp is set for 77 degrees. I unplugged my heater immediately and the temp began to lower. I think I may have plugged my heater in the wrong socket. Before I do process of elimination, is there a way to check through my profilux controller to try and identify which socket I originally programmed for my heater? Thank you.

  2. #2
    Registriert seit
    31.08.2016
    Beiträge
    12

    Standard

    OK, so I found out how to confirm what is plugged where on my Energy Bar. Looks like I mistakenly plugged my heater in a "Always On" socket when I plugged everything back in. What a dumb mistake. I have to find a better way to label my sockets.

Forumregeln

  • Es ist dir nicht erlaubt, neue Themen zu verfassen.
  • Es ist dir nicht erlaubt, auf Beiträge zu antworten.
  • Es ist dir nicht erlaubt, Anhänge hochzuladen.
  • Es ist dir nicht erlaubt, deine Beiträge zu bearbeiten.
  •