One fast question, i cant seem to find anything in the manual about this.
Pump channel, if i want 2 pumps to run in sync, so the 2 vortech pumps always do the same mode/speed should both be set to channel 1 then?
One fast question, i cant seem to find anything in the manual about this.
Pump channel, if i want 2 pumps to run in sync, so the 2 vortech pumps always do the same mode/speed should both be set to channel 1 then?
That depends on how you have the pumps setup.
If you are using the Vortech controller options, you would select a pump and set the mode to Synchronous slave.
If you are assigning a Vortech as a Stream pump, you would first select the pump number to assign, then go to a Stream Group and assign multiple pumps to the same group. This group would then be set to run on PERMANENT mode.
Bookmarks