My mitras always is at 100%. No commands work. Why?
Skickat från min G8141 via Tapatalk
My mitras always is at 100%. No commands work. Why?
Skickat från min G8141 via Tapatalk
some more details about hardware and settings, please
screenshots
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
I have the p4. Mitras lightbar 2 140cm antic. Connected to the mitras outlet on the p4.
Skickat från min G8141 via Tapatalk
1. Go to the MITRAS LIGHTBAR settings page and check the box, Mitras Lightbar present.
2. At the bottom of that page, select the link SYSTEM. You will then be brought to the SYSTEM settings page.
3. In the Communication interfaces section, click 3-times on Standard and set the function to MITRAS LIGHTBAR.
4. Save settings.
Test each channel in Light Composer.
Also check the Mitras Lightbar settings to make sure you have the correct Illumination channels assigned to each channel on the LB2.
Thx it works 😄
Skickat från min G8141 via Tapatalk
Will this cause problem with the usb? If I need to connect if the wifi isint working
Skickat från min G8141 via Tapatalk
Glad to hear it!
You'll still be able to connect via USB, it won't interfere.
Good. Thx again
Skickat från min G8141 via Tapatalk
Bookmarks