New Profilux Owner

[trigger1121]

Hello all

I just bought a ProfiLux Pluss II, and being my first aquarium controller, I'm having trouble getting it started. My Powerbar 6D only flashes the green power led. Does it matter which control line connector I use? On the controller I am using the S1-S4 port and the connector port closet to the indicator lights.

[aqua_digital]

Hi

Use the one closest to the LED's

Go into ProfiLux control software and then extras and then socket function and make sure digital power bar tab at the bottom is checked and press save.

If the power LED is flashing this means there is no communication from the ProfiLux to the power bar, make sure you are also using the cable that has a supressor on each end, this is the data cable for the power bar.

If this does not work, leave the ProfiLux switched off for 30 minutes then apply power again.

I am also assuming the ProfiLux is switched on and has booted ok?

[trigger1121]

Okay, I thought that was the issue, but was second guessing because of the warning. It is working now. Thanks.