P4 - problem with multiple level sensors using Y splitter PL-LY

[OzFisho]

Vinny (or anyone else from GHL ) - do you have any idea why my Profilux 4 is not recognising and attributing the level sensors correctly?

Is it a firmware problem, or port problem, or cable manufacturing error?

What can I do to resolve the problem as I need to use the controller asap?

[JunkieHobbo]

Tagging along here as I have the exact same issue.

Also to note I have tested this with Flow Sensors aswell, the P4 only see's 1 sensor when connect the Y-Cable.

[Vinny]

Are you selecting the correct sensor number to assign to each Control Circuit?

Please post a screenshot of your LEVEL settings.

[Matthias]

Hi

allow us a few days to have a deeper look into this.

Will come back to this topic ASAP.

[JunkieHobbo]

Here it is with the Flow Sensors plugged directly to Port 1 & 3

FlowSensor1and3.JPG

Here it is with the Flow Sensors plugged into a Y Cable on Port 3[Green]

FlowSensorYon3.JPG

Here it is with the Flow Sensors plugged into a Y Cable on Port 1[Purple]

FlowSensorYon1.JPG

I also have the same results as the OP with the float switches.

[OzFisho]

Thanks for posting about you having the same problem JunkieHobbo. Hopefully we can get this sorted out soon!


Vinny / Matthias - attached are three images of my Level Settings, as requested. They are:

- 2 float sensors, triggered, connected directly to Purple and Green Ports (both sensors are recognised by the P4 correctly)

- the same 2 float sensors connected via PL-LY splitter to Purple Port (only 1 sensor being recognised, as sensor 1)

- the same 2 float sensors connected via PL-LY splitter to Gren Port (only 1 sensor being recognised, as sensor 3)


As previously mentioned, I get the same error no matter whether I use float sensors, optical sensors or the leak detect module.

[OzFisho]

Hi Vinny / Matthias. Have you been able to replicate the problem we are experiencing with the P4 level sensors? Do you have any idea how soon it can be fixed?


Thanks very much.

[JunkieHobbo]

Hi Vinny / Matthias. Have you been able to replicate the problem we are experiencing with the P4 level sensors? Do you have any idea how soon it can be fixed?


Thanks very much.

Was about to ask the same thing, You beat me to it!