Results 1 to 4 of 4

Thread: RJ45 Socket on PowerBar 6D PAB

  1. #1
    Join Date
    03.12.2009
    Posts
    188

    Default RJ45 Socket on PowerBar 6D PAB

    Can I get the part number for the RJ45 sockets used on the powerbar 6D

    I have some where the copper pins in them have corroded away and I would like to replace them.
    I am comfortable using hot air and replacing surface mount parts, but I would like to order replacement parts before I pull my working units out of use.

    In total I have 8 powerbars, most have issues around the connector (either with the connector being loose or corrosion of the pins).

    All of the units are out of warranty, so I just need the brand/part number for the parts

    thanks

    Darren
    Stay up to date with my efforts at Blue Tang Breeding here http://facebook.com/RegalTangBreeding and Mccullochi Clownfish Breeding here https://www.facebook.com/MccullochiClownfishBreeding

  2. #2
    Join Date
    28.07.2017
    Posts
    69

    Default

    As long as you have one remaining PAB port left you could daisy chain devices with a RG45 Y-Splitter. CAN can handle that.

    But replacing the actual ports is of course much nicer if you can pull it off.

  3. #3
    Join Date
    03.12.2009
    Posts
    188

    Default

    GHL, can you provide the part number I am looking for.
    I don't need you to supply it (unless you are happy to supply just the socket/connector), I just need the vendor/part number for the connector.

    Thanks
    Stay up to date with my efforts at Blue Tang Breeding here http://facebook.com/RegalTangBreeding and Mccullochi Clownfish Breeding here https://www.facebook.com/MccullochiClownfishBreeding

  4. #4
    Join Date
    11.06.2017
    Location
    Kaiserslautern
    Posts
    80

    Default

    Please contact service@ghl-kl.de for replacements
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •