-
0-10v return pump controlling problem
Just got to run the Aquabee DC 5000 with Controller and 0-10v cable, connected to L1/L2 port, following setting post found in forum here, but the pump seems still working with it's own program and not running anything I set in Profilux, should be anything wrong?
Thank!
-
Not knowing what you have done, the suggestion is that the controller is not set to extern.
Also maybe the wiring is wrong
-
Hi,
The DC pump controller had been connectred to the profilux L1/2, it's set "external" controlled by the aquarium computer(which Profilux 4 is), nothing appeared in the GCC's 0-10v option. I tried plug the 0-10v cable into another yellow L port, (3/4, 5/6) still the same, nothing changed.
Am I doning anything wrong?
-
The cable that connects directly to the L-port should be one that was designed to use with our ProfiLux controller.
Any other cable should be first connected to our LBF-AP accessory, then from the LBF-AP to the ProfiLux.
Since this is connected to the L1/L2 port:
1. Go to the 1-10V INTERFACE settings page and select L1.
2. Set the function to STREAM PUMP 1. This will assign the pump as a Stream pump.
3. Go to an unused STREAM GROUP settings page.
4. Select PUMP 1 from the RIGHT column and click the LEFT-pointing arrow to assign Stream pump 1 to this Stream group.
5. Use the Stream group settings page to set the behavioral patterns of your pump.
6. Save settings.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks