Results 1 to 3 of 3

Thread: Require Help - Connecting Dosing Pumps

  1. #1
    Join Date
    12.12.2009
    Posts
    1

    Default Require Help - Connecting Dosing Pumps

    I have purchased 3 pump dosing unit and tried to connect it to my Profilux.

    I have 2 digital power bars daisy chained to S1-S4(Sockets numbered 1-12) and want to add the doser as sockets 13-15 and be daisy chained to the digital power bars.

    I unplugged the digital power bars from S1-S4 and connected only the doser to S1-S4 and followed the setup instructions and Pump #2 kept spinning

    Please provide steps to enable me to complete the setup.

    Thanks
    Allan

  2. #2
    Join Date
    19.02.2009
    Location
    MANOTICK
    Posts
    866

    Default

    Hi

    If pump two is spinning it is most likely not programmed correctly

    do as you have done so far in regards to plugging the doser into S1S4 directly with nothing else plugged in, make sure power is applied to the doser at time of programming.

    Click program digital power bar/dosing pump

    Select dosing pump numbering

    Set the first number to what you wish it to be i.e #13

    Click program now

    Click ready

    Press load

    Go to socket outlet function and make sure S13 onwards is not set to anything i.e always off.

    Please comment back here on your findings and if no go Matthias will assist further. But I am sure it will work.


    GHL ProfiLux Canada/USA Distribution and support

  3. #3
    Join Date
    18.02.2009
    Location
    Kaiserslautern
    Posts
    7,710

    Default

    I believe the socket function is not adjusted correctly. In older firmware versions the default for channel 2 was bottom heater -> as soon as the water is too cold the channel 2 is activated

    -> set socket functions 1 ... 4 to functions "dosing 1 ... 4 "

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •